Output Routing Menu
This menu page is used to set the output routings from digital inputs to digital outputs.
On all units without AoIP interface, inputs can be looped through or individually routed to the outputs. With the "individual" option selected, every output channel can be fed by any of the available digital inputs, including signals of SDI inputs (if TM7 and TM9 is fitted with the SDI option) and activated BLITS and Stereo Ident generators (if BLITS licence option is activated).
On units with AoIP interface, signals of the activated BLITS and Stereo Ident generators (if BLITS licence option is activated) can be routed to the 32 channels providing them to the AoIP network.
Common settings (not AoIP)
• Output Routing
This key is used to select the loop through or the individual mode for the output routing.
Options: |
|
AES-3 loop through | individual |
Default value: |
|
AES-3 loop through |
back to top
This section is only available, if the "individual" option has been selected for the output routing.
• 1a, 1b, 2a, ..., 7b, 8a, 8b
For each digital output a corresponding key is available. After touching the selected channel key, the available input domains and input channels are displayed in the right half of the menu. Select the parameters you need for the selected channel.
Please note:
Type and number of the available input channels is depending on the selected domain.
Please note:
Output routing modifications will effect all audio groups of this preset.
• Input Domains (in the right resp. lower half of the menu)
These keys are used to set the domain for the output channels or to switch them off. Depending on the selected domain, different types and numbers of the input channels are displayed for selection. If "Off" was selected, no keys are displayed.
Options: |
|
Digital | SDI | Generator | aus |
Default value: |
|
Digital |
• Input Channels (in the right resp. lower half of the menu)
These keys are used to route the input channels to the selected output. The available types and numbers are depending on the selected input domain (see Input Domains option). If "Off" was selected there, no keys are displayed.
Options: |
|
|
for Digital: |
|
1a | 1b | 2a | ... | 7b | 8a | 8b |
for SDI: |
|
I-1 | I-2 | I-3 | I-4 | II-1 | ... | VII-4 | VIII-1 | VIII-2 | VIII-3 | VIII-4 |
for Generator: |
|
L | R | C | LFE | LS | LR | Left | Right |
back to top
• AoIP section: 01, 02, ..., 31, 32
For each digital output a corresponding key is available. After touching the selected channel key, the available input domains and input channels are displayed in the right resp. lower half of the menu. Select the parameters you need for the selected channel.
Please note:
Output routing modifications will effect all audio groups of this preset.
• Input Domains (in the right resp. lower half of the menu)
These keys are used to set the domain for the output channels or to switch them off. Depending on the selected domain, different types and numbers of the input channels are displayed for selection. If "Off" was selected, no keys are displayed.
Options: |
|
Generator | aus |
Default value: |
|
off |
Please note:
The domain Generator is only available with an activated BLITS licence option.
• Input Channels (in the right resp. lower half of the menu)
These keys are used to route the input channels to the selected output. The available types and numbers are depending on the activated BLITS and Stereo Ident signals, see Input Domains option. If "Off" was selected there, no keys are displayed.
Options: |
|
L | R | C | LFE | LS | LR | Left | Right |
back to top
